| タイトル | Modeling bristle lift-off in idealized brush seal configurations |
| 本文（外部サイト） | http://hdl.handle.net/2060/19940017324 |
| 著者（英） | Modi, Vijay |
| 著者所属（英） | Columbia Univ. |
| 発行日 | 1993-10-01 |
| 言語 | eng |
| 内容記述 | We attempt in this paper to develop a model for the flow through brush seals and determine their elastic behavior in order to predict the dependence of brush/journal clearance on geometry and operating conditions. Several idealizations regarding brush seal configuration, flow conditions, and elastic behavior are made in the analysis in order to determine closed form parametric dependence. This formulation assumes that there is no initial interference between the bristle tip and the rotor. Also, interbristle, bristle-backing plate, and bristle-rotor friction is neglected. The bristle bundle or the brush seal as it is alternately called is assumed homogeneous and isotropic on a macroscopic scale so that a physical property like permeability is uniform. The fluid is assumed to be homogeneous, incompressible, viscous, and flowing under steady conditions. A schematic of a brush seal is shown. If the nominal bristle-shaft interference is absent then under static conditions the bristles may deflect axially due to the imposed pressure differential. This axial deflection may create a clearance permitting leakage flow in excess of that which occurs through the porous matrix formed by the bristle bundles. Under dynamic conditions the Couette flow created by shaft motion could be strong enough to cause bristle deflection and once again a clearance may develop. The paper proposes a means to determine this clearance (or at least describe its parametric dependence on geometry and operating conditions) under static as well as dynamic conditions. |
| NASA分類 | MECHANICAL ENGINEERING |
| レポートNO | 94N21797 |
| 権利 | No Copyright |
| URI | https://repository.exst.jaxa.jp/dspace/handle/a-is/114840 |
|
