| タイトル | Flexural fatigue of hollow rolling elements |
| 本文（外部サイト） | http://hdl.handle.net/2060/19760026420 |
| 著者（英） | Bamberger, E. N.; Parker, R. J.; Dietrich, M. W. |
| 著者所属（英） | NASA Lewis Research Center |
| 発行日 | 1976-10-01 |
| 言語 | eng |
| 内容記述 | Hollow cylindrical bars were tested in the rolling-contact fatigue tester to determine the effects of material and outside diameter to inside diameter (OD/ID) ratios of 2.0, 1.6, 1.4, and 1.2 on fatigue failure mode and subsequent failure propagation. The range of applied loads with these OD/ID ratios resulted in maximum tangential tensile stresses ranging from 165 to 655 megapascals (24,000 to 95,000 psi) at the bore surface. Flexural failures of the hollow test bars occurred when this bore stress was 490 megapascals (71,000 psi) or greater with AISI 52100 hollow bars and 338 megapascals (49,000 psi) or greater with AISI M-50 hollow bars. Good correlation was obtained in relating the failures of these hollow bars with flexural failures of drilled balls from previously published full scale bearing tests. |
| NASA分類 | MECHANICAL ENGINEERING |
| レポートNO | 76N33508
E-8621
NASA-TN-D-8313 |
| 権利 | No Copyright |
| URI | https://repository.exst.jaxa.jp/dspace/handle/a-is/184307 |
|
