| タイトル | Comparison of experimental and predicted performance of 150-millimeter-bore solid and drilled ball bearings to 3 million DN |
| 本文（外部サイト） | http://hdl.handle.net/2060/19740021820 |
| 著者（英） | Scibbe, H. W.; Munson, H. E. |
| 著者所属（英） | NASA Lewis Research Center |
| 発行日 | 1974-07-01 |
| 言語 | eng |
| 内容記述 | Seven 150-millimeter-bore ball bearings were run under 8900-newton (2000-lbf) thrust load at speeds from 6670 to 20,000 rpm (1 million to 3 million DN). Four of the bearings had conventional solid balls, and three bearings had drilled (cylindrically hollow) balls with 50-percent mass reduction. The bearings were under-race cooled and slot lubricated with a type 2 ester oil at flow rates from 4.35 x 0.001 to 5.94 x 0.001 cubic meter/min (1.15 to 1.57 gal/min). Friction torque and temperature were measured on all bearings. While there was considerable spread in the temperature data, the drilled ball bearings tended to run slightly cooler than the solid ball bearings at higher speeds. No significant difference in torque was noted, however, between the solid and drilled ball bearings. One bearing of each type was rerun at 17,800-newton (4000-lbf) thrust load. The solid ball bearings performed satisfactorily at 3 million DN. However, at about 2 million DN the drilled ball bearing experienced a broken ball, and cracks appeared in other balls as a result of flexure fatigue. Metallurgical examination of the cracked balls indicated a brittle structure in the bore of the drilled balls. |
| NASA分類 | MACHINE ELEMENTS AND PROCESSES |
| レポートNO | 74N29933
E-7722
NASA-TN-D-7737 |
| 権利 | No Copyright |
| URI | https://repository.exst.jaxa.jp/dspace/handle/a-is/193614 |
