| タイトル | 1998 Calibration of the Mach 4.7 and Mach 6 Arc-Heated Scramjet Test Facility Nozzles |
| 本文（外部サイト） | http://hdl.handle.net/2060/20040120958 |
| 著者（英） | Witte, David W.; Auslender, Aaron H.; Rock, Kenneth E.; Irby, Richard G. |
| 著者所属（英） | NASA Langley Research Center |
| 発行日 | 2004-08-01 |
| 言語 | eng |
| 内容記述 | A calibration of the Arc-Heated Scramjet Test Facility (AHSTF) Mach 4.7 and Mach 6 nozzles was performed in 1998. For each nozzle, three different typical facility operating test points were selected for calibration. Each survey consisted of measurements, at 340 separate locations across the 11 inch square nozzle exit plane, of pitot pressure, static pressure, and total temperature. Measurement density was higher (4/inch) in the boundary layer near the nozzle wall than in the core nozzle flow (1/inch). The results generated for each of these calibration surveys were contour plots at the nozzle exit plane of the measured and calculated flow properties which completely defined the thermodynamic state of the nozzle exit flow. An area integration of the mass flux at the nozzle exit for each survey was compared to the AHSTF mass flow meter results to provide an indication of the overall quality of the calibration performed. The percent difference between the integrated nozzle exit mass flow and the flow meter ranged from 0.0 to 1.3 percent for the six surveys. Finally, a comparison of this 1998 calibration was made with the 1986 calibration. Differences of less than 10 percent were found within the nozzle core flow while in the boundary layer differences on the order of 20 percent were quite common. |
| NASA分類 | Research and Support Facilities (Air) |
| レポートNO | L-19037
NASA/TM-2004-213250 |
| 権利 | No Copyright |
|
