| タイトル | Small Scale Turbopump Manufacturing Technology and Material Processes |
| 本文（外部サイト） | http://hdl.handle.net/2060/20120002797 |
| 著者（英） | Alvarez, Erika; Morgan, Kristin; Zimmerman, Frank; Wells, Doug |
| 著者所属（英） | NASA Marshall Space Flight Center |
| 発行日 | 2011-12-05 |
| 言語 | eng |
| 内容記述 | As part of an internal research and development project, NASA Marshall Space Flight Center (MSFC) has been developing a high specific impulse 9,000-lbf LOX/LH2 pump-fed engine testbed with the capability to throttle 10:1. A Fuel Turbopump (FTP) with the ability to operate across a speed range of 30,000-rpm to 100,000-rpm was developed and analyzed. This small size and flight-like Fuel Turbopump has completed the design and analysis phase and is currently in the manufacturing phase. This paper highlights the manufacturing and processes efforts to fabricate an approximately 20-lb turbopump with small flow passages, intricately bladed components and approximately 3-in diameter impellers. As a result of the small scale and tight tolerances of the hardware on this turbopump, several unique manufacturing and material challenges were encountered. Some of the technologies highlighted in this paper include the use of powder metallurgy technology to manufacture small impellers, electron beam welding of a turbine blisk shroud, and casting challenges. The use of risk reduction efforts such as non-destructive testing (NDT) and evaluation (NDE), fractography, material testing, and component spin testing are also discussed in this paper. |
| NASA分類 | Spacecraft Propulsion and Power |
| レポートNO | M11-0621 |
| 権利 | No Copyright |
|
