| タイトル | Single-Layer, All-Metal Patch Antenna Element with Wide Bandwidth |
| 本文（外部サイト） | http://hdl.handle.net/2060/20120010429 |
| 著者（英） | Chamberlain, Neil F.; Zawardzki, Mark S.; Hodges, Richard E. |
| 著者所属（英） | California Inst. of Tech. |
| 発行日 | 2012-06-01 |
| 言語 | eng |
| 内容記述 | It is known that the impedance at the center of a patch antenna element is a short circuit, implying that a wire or post can be connected from the patch to the groundplane at this point without impacting radiation performance. In principle, this central post can be used to support the patch element, thus eliminating the need for dielectric. In spaceborne applications, this approach is problematic because a patch element supported by a single, thin post is highly susceptible to acoustic loads during launch. The technology reported here uses a large-diameter center post as its supporting structure. The supporting structure allows for the fabrication of a sufficiently rigid antenna element that can survive launch loads. The post may be either hollow or solid, depending on fabrication approach and/or mass constraints. The patch antenna element and support post are envisioned as being fabricated (milled) from a single piece of aluminum or other metal. Alternately, the patch plate and support column can be fabricated separately and then joined using fasteners, adhesive, or welding. Casting and electroforming are also viable techniques for manufacturing the metal patch part(s). The patch structure is then either bonded or fastened to the supporting groundplane. Arrays of patch elements can be fabricated by attaching several structures to a common groundplane/support structure. |
| NASA分類 | Communications and Radar |
| レポートNO | NPO-46843 |
| 権利 | Copyright, Distribution as joint owner in the copyright |
|
