| タイトル | 3-D Printed Ultem 9085 Testing and Analysis |
| 本文（外部サイト） | http://hdl.handle.net/2060/20150017060 |
| 著者（英） | Aguilar, Daniel; Christensen, Sean; Fox, Emmet J. |
| 発行日 | 2015-06-17 |
| 言語 | eng |
| 内容記述 | The purpose of this document is to analyze the mechanical properties of 3-D printed Ultem 9085. This document will focus on the capabilities, limitations, and complexities of 3D printing in general, and explain the methods by which this material is tested. Because 3-D printing is a relatively new process that offers an innovative means to produce hardware, it is important that the aerospace community understands its current advantages and limitations, so that future endeavors involving 3-D printing may be completely safe. This document encompasses three main sections: a Slosh damage assessment, a destructive test of 3-D printed Ultem 9085 samples, and a test to verify simulation for the 3-D printed SDP (SPHERES Docking Port). Described below, 'Slosh' and 'SDP' refer to two experiments that are built using Ultem 9085 for use with the SPHERES (Synchronized Position Hold, Engage, Reorient, Experimental Satellites) program onboard the International Space Station (ISS) [16]. The SPHERES Facility is managed out of the National Aeronautics and Space Administration (NASA) Ames Research Center in California. |
| NASA分類 | Quality Assurance and Reliability; Instrumentation and Photography |
| レポートNO | SPH-04-XS-100
ARC-E-DAA-TN24370 |
| 権利 | Copyright, Distribution under U.S. Government purpose rights |
|
