| タイトル | Prevailing Torque Locking Feature in Threaded Fasteners Using Anaerobic Adhesive |
| 本文（外部サイト） | http://hdl.handle.net/2060/20160008131 |
| 著者（英） | Hess, Daniel P.; Hernandez, Alan |
| 著者所属（英） | NASA Ames Research Center; University of South Florida |
| 発行日 | 2016-05-04 |
| 言語 | eng |
| 内容記述 | This paper presents results from tests to assess the use of anaerobic adhesive for providing a prevailing torque locking feature in threaded fasteners. Test procedures are developed and tests are performed on three fastener materials, four anaerobic adhesives, and both unseated assembly conditions. Five to ten samples are tested for each combination. Tests for initial use, reuse without additional adhesive, and reuse with additional adhesive are performed for all samples. A 48-hour cure time was used for all initial use and reuse tests. Test data are presented as removal torque versus removal angle with the specification required prevailing torque range added for performance assessment. Percent specification pass rates for the all combinations of fastener material, adhesive, and assembly condition are tabulated and reveal use of anaerobic adhesive as a prevailing torque locking feature is viable. Although not every possible fastener material and anaerobic adhesive combination provides prevailing torque values within specification, any combination can be assessed using the test procedures presented. Reuse without additional anaerobic adhesive generally provides some prevailing torque, and in some cases within specification. Reuse with additional adhesive often provides comparable removal torque data as in initial use. |
| NASA分類 | Structural Mechanics; Mechanical Engineering |
| 権利 | Copyright, Distribution under U.S. Government purpose rights |
|
