| タイトル | Creating a Test-Validated Finite-Element Model of the X-56A Aircraft Structure |
| 本文（外部サイト） | http://hdl.handle.net/2060/20160008711 |
| 著者（英） | Truong, Samson; Pak, Chan-Gi |
| 著者所属（英） | NASA Armstrong Flight Research Center |
| 発行日 | 2014-12-12 |
| 言語 | eng |
| 内容記述 | Small modeling errors in a finite-element model will eventually induce errors in the structural flexibility and mass, thus propagating into unpredictable errors in the unsteady aerodynamics and the control law design. One of the primary objectives of the X-56A Multi-Utility Technology Testbed aircraft is the flight demonstration of active flutter suppression and, therefore, in this study, the identification of the primary and secondary modes for the structural model tuning based on the flutter analysis of the X-56A aircraft. The ground-vibration test-validated structural dynamic finite-element model of the X-56A aircraft is created in this study. The structural dynamic finite-element model of the X-56A aircraft is improved using a model-tuning tool. In this study, two different weight configurations of the X-56A aircraft have been improved in a single optimization run. Frequency and the cross-orthogonality (mode shape) matrix were the primary focus for improvement, whereas other properties such as c.g. location, total weight, and off-diagonal terms of the mass orthogonality matrix were used as constraints. The end result was an improved structural dynamic finite-element model configuration for the X-56A aircraft. Improved frequencies and mode shapes in this study increased average flutter speeds of the X-56A aircraft by 7.6% compared to the baseline model. |
| NASA分類 | Structural Mechanics |
| レポートNO | AIAA Paper 2014-3157
DFRC-E-DAA-TN19516 |
| 権利 | No Copyright |
|
