タイトル | Response of Composite Fuselage Sandwich Side Panels Subjected to Internal Pressure and Axial Tension |
本文(外部サイト) | http://hdl.handle.net/2060/19980111019 |
著者(英) | Dopker, Bernard; Rouse, Marshall; Shah, Bharat; Ambur, Damodar R. |
著者所属(英) | NASA Langley Research Center |
発行日 | 1998-01-01 1998 |
言語 | eng |
内容記述 | The results from an experimental and analytical study of two composite sandwich fuselage side panels for a transport aircraft are presented. Each panel has two window cutouts and three frames and utilizes a distinctly different structural concept. These panels have been evaluated with internal pressure loads that generate biaxial tension loading conditions. Design limit load and design ultimate load tests have been performed on both panels. One of the sandwich panels was tested with the middle frame removed to demonstrate the suitability of this two-frame design for supporting the prescribed biaxial loading conditions with twice the initial frame spacing of 20 inches. A damage tolerance study was conducted on the two-frame panel by cutting a notch in the panel that originates at the edge of a cutout and extends in the panel hoop direction through the window-belt area. This panel with a notch was tested in a combined-load condition to demonstrate the structural damage tolerance at the design limit load condition. Both the sandwich panel designs successfully satisfied all desired load requirements in the experimental part of the study, and experimental results from the two-frame panel with and without damage are fully explained by the analytical results. The results of this study suggest that there is potential for using sandwich structural concepts with greater than the usual 20-in. wide frame spacing to further reduce aircraft fuselage structural weight. |
NASA分類 | Composite Materials |
レポートNO | NASA/TM-1998-208213 NAS 1.15:208213 AIAA Paper 98-1708 |
権利 | No Copyright |